Featured Brands
Featured Verticals
DC
Type DC is a sprag type freewheel cage without inner or outer races. It must be installed in a design providing races, bearing support for axial and radial loads, lubrication and sealing. The DC type version-N accepts all types of lubricants currently used in the power transmission equipment.
The sprag space tolerance must not be exceeded. Inner and outer races must both have a minimum plain width “e*”, without any recess, to ensure the freewheel functions correctly as shown on following pages.
Alternatively, races can be made in case hardened steel shafts, or housings, to the specification below. Surface hardness of the finished part should be HRC 60 to 62, for a depth of 0,6 mm minimum.
Core hardness to be HRC35 to 45. Surface roughness not to exceed 22CLA. Maximum taper between races: 0,007 mm for 25 mm width.
LITERATURE-I | LITERATURE-II | LITERATURE-III | LITERATURE-IV | DOWNLOAD DATASHEET
Not sure where to start?
Try our Solution Finder.
Our Solution Finder can find Luna brands and products tohelp your company solve its challenges.
Verticals
Our Company
Our Solutions
Our Solutions
Ethics & Compliance
© 2019 Luna. Luna™, the Luna Logo, and all trademarks and service marks denoted with ™, ℠ or ® are owned by affiliates of Luna. unless otherwise noted.
Verticals
Our Company
Our Solutions
Our Solutions
Ethics & Compliance
© 2019 Luna. Luna™, the Luna Logo, and all trademarks and service marks denoted with ™, ℠ or ® are owned by affiliates of Luna. unless otherwise noted.